Xiaomi Me AIoT AX3600 Wi-Fi 6 router will launch with Mi 10 featuring enterprise Qualcomm Networking Pro 600 IPQ8071

The Xiaomi Mi 10 is going to be the main event on the February 13th online launch event but it has also been revealed that Xiaomi will be launching their first Wi-Fi 6 router, the Mi AIoT AX3600.

It is unlikely we will see an official UK launch, but it could be an interesting router, nonetheless. Xiaomi is famed for its affordable hardware and Wi-Fi 6 devices have been quite expensive since their launch.

The full specification of the router is not known, but apparently,
they have opted to use the Qualcomm Networking Pro 600 Wi-Fi 6 platform which
is supposedly built for enterprise-grade routers.

Xiaomi has highlighted that the Mi AIoT AX3600 Wi-Fi ax
router is the first to use an enterprise-grade platform for the consumer
market.

While that sounds very impressive, looking at the Qualcomm website, this sits at the bottom of their Wi-Fi 6 (802.11ax) network solutions, so it may be enterprise-grade, but you are not likely to see it perform to the same level as other flagship Wi-Fi 6 routers such as the TP-Link Archer AX11000. This should mean that the router fits in with the affordable nature of Xiaomi.

As far as the spec goes, based on the Qualcomm page, you
have 6-spatial streams with peak speeds of 1.7 Gbps, and it likely this will be
dual-band opposed to tri-band of premium routers.

Downlink/Uplink MU-MIMO supports 6 streams of Wi-Fi to
simultaneously connect to MU-MIMO capable clients

Downlink/Uplink OFDMA across all 6 spatial streams to
provide efficient use of spectrum for small data packets supporting up to 37
users

There is support for WPA3 but I suspect it will not be on
the router to start off with, similar to existing WI-Fi 6 routers.

The chipset has support for multi-gig ethernet, but you
almost certainly won’t see it on this router.

The IPQ8071 chipset is based on 4x ARM Cortex A53 CPU cores
running up to 1.0 GHz and it is fabricated on the 14 nm FinFET process.

In comparison, many of the existing high-end Wi-Fi 6 routers
use the Broadcom BCM49408 SoC including the Archer AX11000. This has a 1.8 GHz
quad-core ARMv8 processor (Cortex A53) supplemented by an 800 MHz network
packet co-processor then adopts a tri-band design, with two 4×4 5 GHz radios
and one 4×4 2.4 GHz radio.

Netgear is the few companies to use Qualcomm on the RAX120, and they have the Qualcomm IPQ8074 which is a big step up from the IPQ8071 bumping up the spatial streams to 12 with peak speeds of 4.8 Gbps and the CPU clocks up to 2GHz.

We will find out the full specs of the  Xiaomi Me AIoT AX3600 this Thursday on the 13th.

Like this article?

Share on facebook
Share on Facebook
Share on twitter
Share on Twitter
Share on linkedin
Share on Linkdin
Share on pinterest
Share on Pinterest

Leave a comment